Optional Equipment Connections; Pip Operation With Vcr; Front Control Panel; Pip Operation With Vcr And Cable Box - Panasonic CT-27SL3 Manuel D'utilisation

Optional Equipment Connections

Note: The remote control must be programmed with supplied
codes to operate the optional equipment.

PIP Operation with VCR

This television includes a two tuner Picture In Picture (PIP)
feature. This allows viewing two (2) live broadcasts at the
same time with or without an external video source (VCR).
Note: VIDEO 1 input is a dual-purpose input. It is primarily
intended for connection with 480i devices such as a DVD
player using the Y P
Audio L & R jacks. However, it can also be connected to
conventional composite video sources such as a VCR,
using only the Y/Video jack and Audio L & R jacks. The
on-screen label will display Component or Video 1
depending on which source is connected.
Connect your television to a VCR, as shown.
Note: Do not connect S-Video and Video signal to input 2 at
the same time. If both are connected, signal interference
will result. Use either the S-Video or the video signal
only.
Procedure
Press the PIP button on the Remote Control to display the
PIP frame on screen.
Note: The audio is from the Main Picture only.
To view an external video source in the PIP frame:
• Press the TV/VIDEO button on the Remote Control to
select the same video input to which your VCR is
connected.
• Verify that the VCR is on.
• Choose channels for the Main Picture by pressing the
TV button on the Remote Control and using the numeric
keypad or CH up/down button.
• Choose channels for the PIP frame by pressing the VCR
button on the Remote Control and using the PIP CH up/
down buttons.
Note: The SWAP button switches the PIP and Main Picture
source. Press the RECALL button for on screen PIP and
Main Picture source status.

Front Control Panel

The front control panel can be used to access menus and switch
video mode when the remote control is not available.
Procedure
• Press to select VIDEO input mode.
P component video jacks and
B R
O
PTIONAL

PIP Operation with VCR and Cable Box

This television includes a two tuner Picture In Picture (PIP)
feature. This allows watching two (2) live broadcasts at the
same time with or without an external video source (VCR).
Without a VCR (External Video Source)
Procedure
• Connect incoming cable to antenna (ANT) input on back
of TV.
• Press the PIP button on the Remote Control to display
the PIP frame.
Note: Audio is for the Main Picture only.
• Choose channels for the PIP frame by pressing the
Remote control PIP CH up/down buttons.
• Choose channels for the main Picture by pressing the
Remote Control CH up/down buttons or by using the
numeric keypad.
With a VCR (External Video Source) and Cable Box
Connect your television to a VCR and Cable Box, as shown.
Procedure
• Press the PIP button on the Remote Control to display
the PIP frame.
To view scrambled channels through your Cable Box in the
PIP frame:
• Press the TV/VIDEO button on the Remote Control to
select the same video input to which your VCR is
E C
QUIPMENT ONNECTIONS
5