DeWalt D55154 Guide D'utilisation page 23

CODE POSSIBLE CAUSE
10 Hole in air hose
11 Check valve restricted
12 Air leaks
13 Regulator is damaged
14 Unit operating in damp or humid conditions
15 Restricted air intake filter
16 Engine or pump oil is low
Carbon build-up in pump.
17
Detergent type oil being used in pump
18
19
Motor overload protection switch has tripped
20 Extension cord is wrong length or gauge
21 Loose electrical connections
22 Possible defective motor or starting capacitor
Paint spray on internal motor parts
23
POSSIBLE SOLUTION
Replace air hose.
Remove, clean or replace.
Tighten fittings.
Replace.
Move unit to a dry well ventilated area
Clean or replace air intake filter
Add same type of oil in crankcase to pump. See
Compressor Pump Oil under Maintenance.
Contact a D WALT factory service center or a D
e
authorized service center.
Drain oil and refill pump using DeWALT synthetic or SAE
40, non-detergent air compressor oil.
See Motor Overload under Features.
Check for proper gauge wire and cord length. See
Extension Cords under Installation.
Contact a D WALT factory service center or a D
e
authorized service center.
Contact a D WALT factory service center or a D
e
authorized service center.
Contact a D WALT factory service center or a D
e
authorized service center. Do not operate the compressor
in the paint spray area. See flammable vapor warning.
23
WALT
e
WALT
e
WALT
e
WALT
e