DeWalt DWP849X Traduction De La Notice D'instructions Originale page 33

These heavy-duty polishers are professional power
tools.
DO NOT let children come into contact with the
tool. Supervision is required when inexperienced
operators use this tool.
Electrical Safety
The electric motor has been designed for one
voltage only. Always check that the power supply
corresponds to the voltage on the rating plate.
Your D WALT tool is double insulated in
E
accordance with EN 60745; therefore no
earth wire is required.
WARNING: 115 V units have to
be operated via a fail-safe isolating
transformer with an earth screen
between the primary and secondary
winding.
If the supply cord is damaged, it must be replaced
by a specially prepared cord available through the
D WALT service organisation.
E
Mains Plug Replacement
(U.K. & Ireland Only)
If a new mains plug needs to be fitted:
• Safely dispose of the old plug.
• Connect the brown lead to the live terminal in
the plug.
• Connect the blue lead to the neutral terminal.
WARNING: No connection is to be
made to the earth terminal.
Follow the fitting instructions supplied with good
quality plugs. Recommended fuse: 13 A.
Using an Extension Cable
If an extension cable is required, use an approved
3–core extension cable suitable for the power input
of this tool (see Technical Data).The minimum
2
conductor size is 1.5 mm ; the maximum length
is 30 m.
When using a cable reel, always unwind the cable
completely.
ASSEMBLY AND ADJUSTMENTS
WARNING: To reduce the risk of
injury, turn unit off and disconnect
machine from power source before
installing and removing accessories,
before adjusting or changing set-
ups or when making repairs. Before
reconnecting the tool, depress and
release the trigger switch to ensure
that the tool is off.
Auxiliary Handle (fi g. 1)
WARNING: Before using the tool,
check that the handle is tightened
securely.
An auxiliary handle (e) is supplied with your tool and
can be installed on either side of the gear case.
This handle should be used at all times to maintain
complete control of the tool.
A bale handle (g) is also supplied with the DWP849X
and can be used in place of the auxiliary handle.
Wool Ingestion Shields (fi g. 1, 2)
The wool ingestion shields (j) are designed to reduce
the amount of wool, dust, and debris that gets
ingested by the motor during normal use.
Clean the shields as soon as you start to see
buildup on the outside. To clean the wool ingestion
shields:
1. Remove the mounting screw (l).
2. Slide the shield back toward the trigger end of
the tool and lift it off.
3. Clean with soap and water and a soft bristle
brush.
4. Replace the shield on the tool and tighten the
mounting screw.
Spindle Lock Button (fi g. 1)
NOTICE: To reduce the risk of damage
to the tool, do not engage the spindle
lock while the tool is operating. Damage
to the tool will result and attached
accessory may spin off possibly
resulting in injury.
In order to prevent the spindle of the tool from
rotating while installing or removing accessories, a
spindle lock button (d) has been provided in the gear
head of the machine.
To lock the spindle, depress and hold the lock
button. NEVER DEPRESS THE SPINDLE LOCK
BUTTON WITH THE TOOL RUNNING OR
COASTING.
Attaching and Removing Polishing
Pads (fi g. 3)
WARNING: To reduce the risk of
serious personal injury, do not allow any
loose portion of the polishing bonnet
or its attachment strings to spin freely.
Tuck away or trim any loose attachment
EN G LI SH
31