Table Des Matières; Meanings Of Symbols - Tanaka TCG 24EBSP SL Mode D'emploi

English

MEANINGS OF SYMBOLS

NOTE: Some units do not carry them.
Symbols
WARNING
The following show symbols used for the machine. Be sure that you understand
their meaning before use.
It is important that you read, fully
understand and observe the
following safety precautions and
warnings. Careless or improper
use of the unit may cause serious
or fatal injury.
Read, understand and follow all
warnings and instructions in this
manual and on the unit.
Always wear eye, head and ear
protectors when using this unit.
Keep all children, bystanders
and helpers 15 m away from
the unit. If anyone approaches
you, stop the engine and cutting
attachment immediately.
Be careful of thrown objects.
Shows maximum shaft speed. Do
not use the cutting attachment
whose max rpm is below the
min
-1
shaft rpm.
Gloves should be worn
when necessary, e.g., when
assembling cutting equipment.
Use anti-slip and sturdy footwear.
Before using your machine
• Read the manual carefully.
• Check that the cutting equipment is correctly assembled and adjusted.
• Start the unit and check the carburetor adjustment. See "MAINTENANCE".
Contents
WHAT IS WHAT .................................................... 3
WARNINGS AND SAFETY INSTRUCTIONS ........ 4
SPECIFICATIONS ................................................. 6
ASSEMBLY PROCEDURES ................................. 8
OPERATING PROCEDURES .............................. 10
MAINTENANCE .................................................. 12
TROUBLESHOOTING......................................... 16
2
Choke - Run position (Open)
Choke - Start position
(Closed)
Ignition stop
Fuel and oil mixture
Guaranteed Sound power
4
level
Hot surface - Contact with
hot surface can cause serious
burns.
Indicate handle location. Do
not attach handle above this
point.
Indicates cutting attachment
guard location for a trimmer
head or semi-auto cutting
head.