Siemens SINUMERIK 840D sl Manuel De Mise En Service page 1304

Configuration du système
2.3 Fichier de configuration "basesys.ini"
; from TCU or IBN net
; (X120 anad X127, resp.) to external net (X130).
; If set to "X120" or "X127", forwarding will only be
; disabled from that interface.
;DisableNATRouting=1
[IBNInterface]
; If DisableIBNNet is set to 1, the whole interface will be disabled
;DisableIBNNet=1
; Setting EnableDHCPD_IBNNet to 0 suppresses that a DHCP server
; is started on that interface
;EnableDHCPD_IBNNet=0
; If DisableIBNForwarding is set to 1, the NCU won't do NAT routing
; from IBN network (X127) to system network (X120).
;DisableIBNForwarding=1
; If EnableSysNetToIBNForwarding is set to 1, the NCU forwards
; packets from X120 to X127. (Please note that the sending host must
be
; able to route the packets to the NCU by its own means, the NCU just
; accepts and forwards packets to 192.168.215.x with this setting.)
;EnableSysNetToIBNForwarding=1
[SNMP]
; The following variables define strings which are delivered on
; certain SNMP requests.
; SNMPLocation and SNMPContact are reported for the standard OIDs
; SNMPv2-MIB::sysLocation and SNMPv2-MIB::sysContact, resp.
; SNMPAutLocation and SNMPFunction are used in the Siemens A&D
specific
; AUTOMATION-SYSTEM-MIB as
automationSystemIdent.automationLocationTag
; and automationSystemIdent.automationFunctionTag, resp.
SNMPLocation="not specified"
34
Manuel de mise en service, 10/2020, A5E48312736D AB
Système d'exploitation NCU