Applying Sliding Aids; The Unravelling/Unfolding Technique - arjo MaxiSlides Mode D'emploi

Applying sliding aids

Figure 1
Figure 2
Figure 3
Figure 4
APPLYING SLIDING AIDS

The unravelling/unfolding technique

(8 Steps)
If using a draw sheet, this technique can be used by
placing the sliding aid between the draw sheet and
the transfer surface.
1. Adjust the bed into an appropriate height for the
caregivers, avoiding the need to overstretch.
2. Fold the sliding aid in approximately 20 cm / 8 in.
folds. (See Figure 1)
NOTE
Fold the two MaxiSlide sheets together, on
top of each other.
Make sure the closed side of the MaxiTube is
in the direction of the movement.
3. Turn the folded sliding aid over, so the folded side
is closest to the transfer surface. (See Figure 2)
4. Place the folded sliding aid under the patient's
head and pillow to unravel from head to feet.
(See Figure 3)
5. Hold the top end of the sliding aid with your
outside hand to secure the sliding aid in position.
6. Use clear commands and simultaneously unfold
the sliding aid in stages - one fold at a time - with
your inside hand while keeping the back of the
hand in contact with the support surface. Do not
pull upwards. (See Figure 4).
7. Unfold the folds by pulling slightly outwards
away from the patient as at and stretched out
as possible to avoid wrinkles causing friction or
shear.
8. Pull and straighten out the sliding aid, and draw
sheet, as needed.
EN
9