Applying The Sling - arjo Sara 3000 Notice D'utilisation

Applying the Sling

In Chair/Wheelchair (17 steps)
For transfer/transport see the
1. Place
2. Apply the brakes on the wheelchair.
3. In case of using
you:
• Fold up the seat pads and let the patient
EN
step up onto the
• Fold down the seat pads and let the
patient sit down.
4. Place the sling around the patient's lower
back. If needed, slightly lean the patient
forward. (See Fig. 5 – Stedy ) or
(See Fig. 6 – Lite/3000/Flex)
5. For machine washable slings and Flites:
Position the bottom of the sling, aligned
For wipeable sling: Position the wipeable sling
centred around the patient's waistline.
Make sure that:
• patient's arms are outside the sling,
• support belt is positioned loosely
around the patient's body and
• support belt is not twisted or
trapped behind the patient's back.
7. In case of using Sara 3000, Sara Flex lift,
legs and these are not twisted. (See Fig. 7 )
8. Fasten the support belt securely by pressing
the buckles or hook and loop attachments
together. The support belt should be tight
but comfortable for the patient.
WARNING
To avoid injury to the patient, pay close
attention when lowering or adjusting
the spreader bar.
Fig. 5 –
Stedy
nearby.
lift, make sure
.
Fig. 6 – Fig. 7
Lite/3000/Flex
9. Position the
lift in front of the patient. Open up the lift legs,
if needed. See appropriate lift IFU.
10. Apply the brakes on the lift.
11. Place the patient's feet on the lift foot support.
In case of using
Flex lifts, make sure the patient's legs are in
contact with the knee support.
12. Attach the sling to the lift. See "Clip
Attachment & Detachment" on page 7 and
(See Fig. 8 )
If the attachment strap is too loose, choose
the inner attachment clip. If the attachment
strap is too tight, choose the outer attachment
clip.
13. Transfer sling only
loops to the central lug on the Sara 3000,
Sara Flex
(See Fig. 9 )
WARNING
To avoid the patient from falling, make sure
that the sling attachments are attached
securely before and during the lifting
process.
14. Make sure that all clips/loops are attached
securely and the patient is comfortable
in the sling. (See Fig. 3 )
15. If an adjustment is needed, lower the patient
and make sure that the weight of the patient
is taken up by the receiving surface before
removing the clip/loop.
Encourage the patient to assist during the
raising exercise by holding on to the support
grips with both hands.
17. Continue raising until the patient is in a
comfortable standing position. Make sure
the patient leans back against the sling
at all times. See corresponding lift IFU.
Fig. 8
8
Fig. 9
Sara 3000
Sara Flex