Christopeit Sport X3 Bike Black Edition Notice De Montage Et D'utilisation page 18

Cleaning, Checks and Storage of the home bike:
1. Cleaning
Use only a less wet cloth for cleaning.
Caution: Never use benzene, thinner or other aggressive cleaning
agents for surface cleaning as this damage caused.
The device is only for private home use and for use suitable indoors.
Keep the unit clean and moisture from the device.
2. Storage
Remove the batteries from the computer while intending the unit
for more than 4 weeks not to use. Push the saddle slide toward the
handlebar and the seat support tube as deeply as possible into the
frame. Choose a dry storage in-house and put some spray oil to the
pedal bearings left and right, and on the thread of the handgripscrew
for saddle support.
Cover the bike to protect it from being discolor by any sunlight and
dirty through dust.
3. Checks
We recommend every 50 hours to review the screw connections for
tightness, which were prepared in the assembly. Every 100 opera-
ting hours, you should put some spray oil at the pedal bearings left
and right, and to the thread of handgripscrew for saddle support.
Training area in mm
(for home trainer and user)
Troubleshooting
If you cannot solve the problem with the following information,
please contact the authorized service center.
Problem Possible Cause
Computer No Batteries insert
has no value or batteries empty
at Display if
you press any
key.
Computer is Sensor impulse
not counting missing base on
data and do not well plugged
not switch connection
on after start
cycling.
Computer is Sensor impulse
not counting missing base on
data and do not correct position
not switch of sensor.
on after start
cycling.
No pulse Pulse sensors not
value well connected
Resistance Connection of resi-
don't change stance not well
Free area in mm
(Training area and security area
(rotating 60cm))
18
Solution
Check the position of batte-
ries at battery compartment or
replace batteries.
Check the plug connections at
computer.
Take off the cover and check
the distance between magnet
and Sensor. The magnet at
turning belt wheel should have
only less than < 5mm distance
against the sensor position.
Screw out the screw for pulse
measurement and check if
plugs are well connected and no
damage at pulse cable.
Check the resistance connec-
tion inside the housing in regard
to well connection.