Publicité
Les langues disponibles
Les langues disponibles
Assembly Instructions
Remove all the separate parts from the packaging, lay them on
the floor and check roughly that all are there on the base of the
assembly steps. Assembly time approx.. 15-20min.
Step 1:
Installation of front and rear foot (2+3) to the both frames (1+43).
1. Place two screws M8x55 (12), and each two curved washers
8//19 (13), spring washers M8 (47) and cap nuts M8 (14)
accessibly beside the front and rear parts of the frames (1+43).
2. Insert the foot bars (2+3) in the holder of frames (1+43) and
adjust so that the holes of the holders and the foot bars (2+3)
are aligned. The rear foot (3) has preassembled eccentric caps
(41).
3. Push one screw (12) through each hole.
4. Fit the screw ends of (12) with each one washer (13), spring
washer (47) and fasten with a cap nut (14).
(Note: If the machine has positioned for training on an uneven
floor, this can be compensated at any place by turning the
eccentric caps (41).
5. Connect the elastic rope (53) with carbine hooks (51) at ankle
strap (50) and front foot (2).
Step 2:
Installation of handlebar (5) and computer (8) at frame (1).
1. Lead the handlebar (5) against top of the main frame (1), insert
and adjust so that the holes in the handlebar (5) and main frame
(1) are aligned. Put one spring washer M6 (24) and washer 6//12
(22) on each screw M6x15 (23). Push the screws (23) through the
holes in the frame (1), screw into the threaded holes of handlebar
(5) and tighten firmly.
2. Insert the batteries (Type "AAA"-1.5 V pencells) by watching for
the right polarity on the back of the computer (8). (Batteries for
the computer are not included in this item. Please buy them at
your located market.)
3. Connect the plug of connection cable (19) with computer (8).
13
Publicité
