Declaration Of Conformity; Mounting And Operation - Bosch ART 35 Notice Originale

Masquer les pouces Voir aussi pour ART 35:
Table des Matières

Publicité

Les langues disponibles
  • FR

Les langues disponibles

  • FRANÇAIS, page 12
OBJ_BUCH-1800-004.book Page 10 Monday, September 26, 2016 10:53 AM
10 | English

Declaration of Conformity

We declare under our sole responsibility that the product described un-
der "Technical data" is in conformity with all relevant provisions of the
directives 2011/65/EU, until 19 April 2016: 2004/108/EC, from 20
April 2016 on: 2014/30/EU, 2006/42/EC, 2000/14/EC including
their amendments and complies with the following standards:
EN 60335‚ EN 50581.
2000/14/EC: Guaranteed sound power level:
Conformity assessment procedure according to Annex V.
Equipment category: 33
Notified body:
SRL, Sudbury, England, Nr. 1088
Technical file (2006/42/EC, 2000/14/EC) at:
Bosch Lawn and Garden Ltd., PT-LG/ENS4,
Stowmarket, Suffolk IP14 1EY, England
Henk Becker
Helmut Heinzelmann
Executive Vice President
Head of Product Certification
Engineering
PT/ECS
Robert Bosch Power Tools GmbH
70538 Stuttgart, GERMANY
Stuttgart, 01.01.2017

Mounting and Operation

 Do not connect the machine to the mains socket before
it is completely assembled.
 The cutting line continues to rotate for a few seconds
after the trimmer is switched off. Allow the motor/cut-
ting line to stop rotating before switching "on" again.
 Do not rapidly switch off and on.
 Do not hand bump the line feed as it could be hot.
Troubleshooting
Problem
Trimmer fails to operate
Trimmer runs intermittently
Garden product labours
F 016 L81 462 | (26.9.16)
dB(A)
 Remove any grass from spool cover when changing line
or spool.
 Only use Bosch approved cutting line. Cutting perfor-
mance will vary with different cutting line.
 Use the original spring when replacing spool.
Action
Delivery Scope
Connecting the Shaft
Mounting the Auxiliary Handle
Mounting the Cutting Guard
Attaching the Shoulder Strap
Connecting the Extension Lead
Starting
Stopping
Working Advice
Feeding the Line
Replacing the Line Spool
Winding Line on Spool
Fitting Spool into Spool Holder
Maintenance, Cleaning and Storage
Selecting Accessories
Possible Cause
Power turned off
Mains socket faulty
Extension cable damaged
Fuse faulty/blown
Extension cable damaged
Internal wiring of garden product dam-
aged
Grass too high
3 600 H78 M21
3 600 H78 M00
3 600 H78 M40
3 600 H78 M70
96
97
Figure
1
2
3
4
5
6
7
7
8
9
10
11
12
13 – 14
15
Corrective Action
Turn power on
Use another socket
Inspect cable, replace if damaged
Replace fuse
Inspect cable, replace if damaged
Contact Service Agent
Contact Service Agent
Cut in stages
Bosch Power Tools

Publicité

Table des Matières
loading

Table des Matières