Electrical Safety - Bosch ART 35 Notice Originale

OBJ_BUCH-1800-004.book Page 8 Monday, September 26, 2016 10:53 AM
8 | English
 Never allow children or people unfamiliar with these in-
structions to use the trimmer. Local regulations may re-
strict the age of the operator. When not in use, store the
trimmer out of reach of children.
 Never operate the trimmer with missing or broken guards
or shields or without guards or shields in position.
 Before use check the supply and extension cord for signs
of damage or ageing. If the cord becomes damaged during
use, disconnect the cord from the supply immediately. DO
NOT TOUCH THE CORD BEFORE DISCONNECTING THE
SUPPLY. Do not use the trimmer if the cord is damaged or
worn.
 If the supply cord is damaged, it must be replaced by the
manufacturer, its service agent or similarly qualified per-
sons in order to avoid a hazard.
 Keep extension cords away from cutting elements.
 Before using the machine and after impact, check for signs
of wear or damage and repair if necessary.
 Never operate the product when you are tired, ill or under
the influence of alcohol, drugs or medicine.
 Always wear long heavy trousers, boots and gloves. Do not
wear loose clothing, jewellery, short trousers, sandals or
go barefoot. Secure hair so that it is above shoulder level to
avoid entanglement with moving parts.
 Wear safety eye protection and ear defenders when
operating the machine.
 Keep firm footing and balance. Do not overreach.
 Never work with this trimmer while people, especially chil-
dren or pets are nearby.
 The operator or user is responsible for accidents or dam-
age that occur to people or property.
 Wait until the cutting head has completely stopped before
touching it. The head continues to rotate after the trimmer
is switched off, the cutting system can cause injury/dam-
age.
 Work only in daylight or in good artificial light.
 Operating the trimmer in wet grass decreases the efficien-
cy of performance.
 Switch off when transporting the trimmer to and from the
area to be worked on.
 Switch on the trimmer with hands and feet well away from
the rotating line.
 Do not put hands or feet near the cutting system.
 Never fit metal cutting elements to this trimmer.
 Inspect and maintain the trimmer regularly.
 Have the trimmer repaired only by an authorized customer
service agent.
 Always ensure that the ventilation slots are kept clear of
debris.
 Take care against injury from the blade fitted for cutting
the nylon line length. After feeding line always return the
trimmer to its horizontal operating position before switch-
ing on.
F 016 L81 462 | (26.9.16)
 Switch off and remove the plug from the socket:
– whenever you leave the machine unattended for any
period
– before replacing the cutting lline
– if the cable is tangled
– before cleaning or working on the trimmer
– before removing the trimmer attachment
 After use, disconnect the machine from the mains and
check for damage.
 Store the machine in a secure, dry place out of the reach of
children. Do not place other objects on top of the machine.
 Replace worn or damaged parts for safety.
 Ensure replacement parts fitted are Bosch approved.
 Do not operate the machine without the trimmer at-
techment fitted.

Electrical Safety

 Warning! Switch off, remove plug from mains before
adjusting, cleaning or if cable is cut, damaged or entan-
gled.
 The cutting line continues to rotate for a few seconds
after the trimmer is switched off.
 Caution – do not touch rotating cutting line.
Your machine is double insulated for safety and requires no
earth connection. The operating voltage is 230 V AC, 50 Hz
(for non-EU countries 220 V). Only use approved extension
cables. Contact your Bosch Service Centre for details.
It is recommended for increased electrical safety to use a
Residual Current Device (RCD) with a tripping current of
not more than 30 mA. Always check your RCD every time
you use it.
For products not sold in GB:
WARNING: For your safety, it is required that the plug at-
tached to the machine is connected with the extension cord.
The coupling of the extension cord must be protected against
splash water, be made of rubber or coated with rubber. The
extension cord must be used with a cable strain relief.
The connection lead must be inspected for signs of damage at
regular intervals and may only be used if in perfect condition.
If the supply cord is damaged, it must be replaced by a Bosch
Service Centre.
Extension cords/leads should only be used if they comply
with H05VV-F or H05RN-F types.
Products sold in GB only: Your product is fitted with an
BS 1363/A approved electric plug with internal fuse (ASTA
approved to BS 1362).
If the plug is not suitable for your socket outlets, it should be
cut off and an appropriate plug fitted in its place by an author-
ised customer service agent. The replacement plug should
have the same fuse rating as the original plug.
The severed plug must be disposed of to avoid a possible
shock hazard and should never be inserted into a mains sock-
et elsewhere.
Products sold in AUS and NZ only: Use a residual current de-
vice (RCD) with a rated residual current of 30 mA or less.
Bosch Power Tools