Tool Specifications; Operating Controls; For Your Safety - Bosch GNF 65 A PROFESSIONAL Instructions D'emploi

3 609 929 482 - Buch Seite 1 Donnerstag, 28. August 2003 2:34 14

Tool Specifications

Wall Chaser
Part number
Rated input power [W]
Output power [W]
Idling speed [rpm]
Diamond cutting
discs Ø, max. [mm]
Mounting hole [mm]
Slot depth [mm]
Slot width [mm]
Weight without
cable, approx. [kg]
Safety class
Please observe the order number of your machine.
The trade names of the individual machines may vary.

Operating Controls

The numbering of the machine elements refers to
the representation of the machine on the graph-
ics page.
While reading the operating instructions, unfold
the graphics page for the machine and leave it
open.
1 On/Off switch
2 Cutting depth scale
3 Adjustment screw
4 Quick-clamping lever for protective cover
5 Clamping nut
6 Spacing disc
7 Diamond cutting disc*
8 Mounting flange
9 Grinder spindle
10 Chaser rollers
11 Auxiliary handle
12 Locking screw for auxiliary-handle holder
13 Spindle locking button
14 Protective cover with cutting guide
15 Clamping lever for cutting depth
pre-selection
16 Extraction elbow
17 Vacuum hose*
18 Break-out tool
19 Two-hole wrench for clamping nut
* Not all the illustrated or described accessories are
included as standard delivery.
4 • 3 609 929 482 • TMS • 25.08.03
All manuals and user guides at all-guides.com
GNF 65 A
PROFESSIONAL
0 601 368 7..
2 400
1 670
5 000
230
22.2
20 – 65
8 – 40
8.4
/ II
English - 1

For Your Safety

Working safely with this ma-
chine is possible only when the
operating and safety information
is read completely and the in-
structions contained therein are
strictly followed. In addition, the
general safety notes in the en-
closed booklet must be ob-
served. Before using for the first
time, ask for a practical demon-
stration.
Wear protective glasses and ear protection.
Wear additional protection equipment for your
safety, such as protective gloves, sturdy
shoes, hard hat and apron.
When working with the machine, always hold it
firmly with both hands and make sure you are
in a secure standing position.
If the cable is damaged or cut through while
working, do not touch the cable and pull the
plug immediately. Never use the machine if the
cable is damaged.
Always direct the cable to the rear away from
the machine.
Connect machines that are used in the open
via a residual current device (RCD) with an ac-
tuating current of 30 mA maximum. Do not op-
erate the machine in rain or moisture.
Don't work with materials containing asbestos.
Only use diamond cutting discs with a maxi-
mum permissible speed that is at least as high
as the no-load speed of the machine.
Check the diamond cutting discs before use.
The diamond cutting discs must be mounted in
exact alignment and be able to rotate freely.
Carry out a test run for at least 30 seconds
without any load. Do not use any diamond cut-
ting discs that are damaged, out-of-balance, or
vibrate.
Observe the dimensions of the diamond cut-
ting discs. The diameter of the hole must fit the
mounting flange 8 . Do not use any reduction
parts or adapters.
Protect diamond-cutting discs against impact,
shock and grease.
Secure the workpiece. Clamping devices or a
vise will hold the workpiece in place better than
the hand.
Apply the machine to the workpiece only when
switched on.