SFA SANIFOS 110 Notice D'installation page 131

Assembling the connector
Tightening torque: 0.5 nm
(DIN 5264 A)
Connection and connector lock
The right-hand part is already mounted on the SMART control
box..
Connection to the SMART control unit
Pump 1: Pump 1
Pump 2: Pump 2
OFF: Low level float
ON: High level float
ALARM: Alarm float
Closing the connector
Tightening torque: 1.5 - 2 nm
Unlocking and disconnecting the connector
Note: It is important to keep a minimum radius for the connectors.
In order to avoid tensile forces, it is recommended to:
• Fold the cable as recommended opposite
• Cut the cable to the proper length
• Strip cables and wires
Opening the connector
Motor connector wiring
Position 1: Brown wire
Position 2: Blue wire
Position 3: White wire
UK
131