Installation / Assembly; Installing The Pumping Station, Floor-Standing - SFA SANIFOS 110 Notice D'installation

5. INSTALLATION / ASSEMBLY

• PVC pressure PN10 or 16 (recommended by the manufacturer)
• Flexible "reinforced" type HDPE

5.1 Installing the pumping station, floor-standing

• The characteristics shown on the rating plate have been compared with those on the order and installation (supply voltage, frequency).
• The installation room must be protected against frost.
• The installation room is adequately lit.
• The work has been prepared in accordance with the dimensions shown in the example installation and standard EN 12056-4.
• The plant room where the SANIFOS
facilitate maintenance.
• Stop valves (provided with certain devices) must be fitted on the effluent inlets as well as on the discharge line, as close as possible to the
pumping station.
• The discharge line must be designed to prevent any back-flow of sewage.
By fitting a non-return loop, located above the back-flow level, back-flow is avoided.
Please note: Unless otherwise specified locally, the back-flow level is the level of the highway (roads, pavement, etc.). Extend this line after
the non-return loop through a larger diameter pipe.
• Provide a sump to drain the room.
• The installation of an auxiliary pump for possible drainage of the plant room (for floods) is recommended.
• The pumping station must be ventilated above the roof.
• The pumped fluid is appropriate and authorised by this documentation.
(➜ section 3.5, page 12)
• In case of discharge of greasy effluents, the use of a degreasing tank is essential.
Wastewater other than those mentioned above, for example, of artisanal or industrial origin, must not be discharged into the pipes without
prior treatment.
SANIFOS 110 installation
®
SANIFOS 250 installation
®
with extension
will be installed must be large enough to allow a 600 mm clearance around and above the device to
®
UK
127