Publicité
M.-Nr. 11819270
en-US
Installation instructions for XCI box PDR14–44 kg
Parts included
Quantity Mat. no.
Designation
1
XCI box
1
Mounting bracket for XCI box
4
Allen screw, M4 x 16
4
M4 nut, DIN 934 GAL/ZN
4
Washer M4 A2
5
Raised-head screw M4 x 12.5 (only 4 are required)
Danger due to incorrect service work
WARNING
Danger due to incorrect service work.
There is a risk of serious damage, injury, or even death if service work is carried out incorrectly.
A
Service work may only be carried out by a qualified service technician with specialist training, knowledge and
experience.
A
All applicable safety guidelines must be followed.
A
Wear personal protective equipment.
A
Read the Miele service documentation before starting service work.
The "Miele Service Documentation" (MSD) service application is required for all service work
The warning and safety instructions given in the model-specific technical service documentation must be observed.
Service work must be done following the model-specific work instructions.
Securing the XCI box with mounting bracket to the tumble dryer
A
Remove the screws (1) from the lid of the XCI box; see Fig. 1.
A
Fold the lid of the XCI box up and back.
A
Screw the 2 cylindrical screws loosely to the mounting bracket with 1 washer and 1 nut attached to each of them;
see Fig. 2.
A
Position the top of the XCI box on the screws on the mounting bracket; see Fig. 3.
A
Screw the bottom of the XCI box to the mounting bracket using the 2 cylindrical screws with 1 washer and 1 nut
attached to each of them; see Fig. 3.
A
Screw the nuts tightly at the top.
A
Drill a 3mm hole at each of the 4 corners (1) on the back of the dryer; see Fig. 4.
A
Screw the XCI box to the rear panel of the tumble dryer with 4 raised-head M4 x 12.5 screws; see Fig. 5.
A
Connect the XCI box as described in the operating instructions.
A
Install the lid on the XCI box.
en-US
Diese Unterlagen dürfen ohne unsere Genehmigung weder vervielfältigt noch Dritten zugänglich gemacht werden. Eigentumsrechte vorbehalten.
Umbau- und Montageanweisung
7 von 10
11.05.2021
Publicité
