Wilo Stratos ECO 16F Instructions De Montage Et De Mise En Service page 10

English
7.2 Electrical wiring
WARNING! Risk of electrical shock!
Dangers caused by electrical energy must be excluded.
• Electrical work by a qualified electrician only!
• National Electric Codes, local codes and regulations must be strictly
followed.
• All electrical connections must be performed after the electrical supply has
been switched off and secured against unauthorised switching.
• For safe installation and operation a proper grounding of the pump to the
power supply's grounding terminals is required.
• Power supply must correspond to name plate data
(115 V or 230 V single phase, 60 Hz).
• The pump must be connected to the power supply with a grounded plug-
connection per local electrical codes.
• The motor is impedance protected so motor overload protection is not required.
• A minimum cable size of 14 AWG should be used (refer to the local codes).
NOTE: When using the pump in systems with water temperature exceeding
194 °F (90 °C) a power cable with corresponding temperature rating must be used.
• The supply cable must be positioned so that it never touches the pipework and/
or the pump and motor casing.
• The connecting cable can be fed through the cable entry either above or below the
terminal box. The cable entry which is not used must be closed by a blind plug.
• Connect power as shown in (Fig. 4).
• power connections: L, N, PE (ground).
• max. line fuse: 10 A, slow action.
• The connecting cable can optionally be lead through the cable gland on either
right or left.
• Strictly comply with local grounding regulations.
• All wiring to comply with local regulations.
Fig. 4
8 Subject to technical alterations! WILO AG 11/2007