Ebm Installation - Eaton Powerware 5125 Guide D'installation

INSTALLATION

EBM Installation

NOTE Up to four EBMs may be connected to the UPS. If there are two UPSs in a rack, up to
two EBMs may be connected to each UPS.
To install an optional EBM(s):
1.
2.
3.
Communication Port
UPS Battery
Connector
REPO Port
EBM Battery
Connectors
6
EATON Powerware
UPS
Optional
EBMs
Figure 5. Rack-Mount UPS with EBMs
Verify that all battery circuit breakers are in the OFF (O) position
(see Figure 6).
Plug the EBM cable(s) into the battery connectors as shown in
Figure 6. Up to four EBMs may be connected to the UPS.
Continue to the following section, "UPS Installation."
Input Connector Power Cord
Figure 6. Typical EBM Installation
®
5125 (9910-P33) UPS Installation Guide for IBM
Circuit Breakers
Output
Receptacles
EBM
Cable
ON OFF
Battery Circuit Breaker
® S
Applications 164201634 Rev A