grandimpianti WFEC 8 Instructions Pour L'installation Et Mode D'emploi page 22

Be very careful during maintenance. NEVER
skip or ignore safety devices. Use only
original spare parts. If doubts should arise,
contact your sales person immediately,
explaining what the fault is and indicating
some information on the machine: model
and serial number (details reported on the
rating plate appearing on the rear of the
machine).
MONTHLY INSPECTION
SERVICING
Clean the strains located on the outer part of
the electrically driven valves.
Make certain that the steam valve strain is
clean (this applies to steam-heated machines
only).
Clean the soap dispenser from any soap
remains.
Clean the door gasket and the tub inlet with
a cloth.
Always keep forced-cooling slots and
openings free from dust (the fan sucks fresh
air from the room), which are on the rear of
the machine, where the speed changer is
housed.
YEARLY INSPECTION AND
SERVICING
Make certain that the floor fastening nuts are
securely closed.
Check the wear of the belts and replace them
if necessary. If more than one of them is
worn out, replace the entire set of belts.
Make sure that the safety devices are working
properly (e.g. door and tilt microswitch).
Check that the floor fastening screws are
tight.
Make certain that the power connecting
screws are tight on the contactors and the
terminal board.
Disassemble the drain valve and clean it
inside from lint.
Check that heaters are in perfect condition
and clean them from scale.
BEFORE TURNING THE MACHINE
ON BY THE CUTOFF SWITCH ON
THE WALL, PUT ALL THE PANELS
REMOVED BACK IN PLACE.
AUTOMATIC MAINTENANCE
REQUEST
The machine keeps count of the number of
cycles it executes. After 1000 programs the
machine will flash the writing "10 00 C" for
10 seconds as the START button is pressed,
to remind the user that scheduled
maintenance is needed. Then it will carry out
the selected cycle normally.
AND
To remove this message and start the cycle
count over again, push the "-" key for 5
seconds with the door closed. The display
will read the total no. of cycles carried out.
To reset the cycle count, pressing the "-" key
again within 10 seconds.
To call off this reading and start the 1000
cycle count from scratch, press the push-
button "-" for at least 5 secs with the door
closed. Then the total number of cycles
performed is viewed and, if the push button
"-" is pressed again within 10 seconds, the
count is set to zero and ready to start back
again.
8.5 IDENTIFYING AND ORDERING
SPARE PARTS
To identify the codes of spare parts refer to
the exploded drawings and relevant list. Once
you have identified your codes, send a
standard written order to the manufacturer,
mentioning clearly the model, serial number,
feed voltage and frequency of your appliance
and, of course, including the code and
description of the spare part you need.
9. SUGGESTIONS FOR MACHINE
LAY UP, DISMANTLING AND
DISPOSAL
If the washing machine is no longer to be
used, it is advisable to put it out of service
and suitably dispose of the resulting
materials, considering the indications
provided in chapter 3. For the sake of the
environment, please sort the materials in
accordance with the waste disposal
provisions in force in your country, so that
they can be properly disposed of or recycled.
All of the parts composing the machine can
be treated as solid urban waste, except for
the metal parts, which nevertheless are not
classed among special waste in most
European countries.
22