Start Up; Configuration - Ecolab MULTRONIC Manuel Technique

4

Start up

4.1

Configuration

The main menu for adjusting the Multronic can be accessed through operating the ↑-key
in the measuring mask.
Main menu
Select configuration through placing the cursor onto the selected function and operate
the ENTER key.
Configuration menu
Select module configuration through placing the cursor onto the selected item and
operate the ENTER key.
Configuration
module selection
(not available at
Multronic OC!)
The conductive C-measuring module that is to be configured can now be selected. To do
so, move the cursor onto the corresponding selected item and operate the ENTER key.
The adjustment of the conductive C-measuring module configuration is carried out on
two pages.
Conductive C
measurement
configuration page 1
The temperature unit function is used to select the temperature unit.
Value range: Celsius / Fahrenheit
417101802_Anhang02_LF_konduktiv.doc
Conductivity Measuring Module (contact measurement)
- 32 - Rev.: 05-07/10