Miele professional WS 5080 Mode D'emploi page 55

Cleaning and Care
Once the flow of suds stops, completely remo-
ve the filter lid together with the filter.
Clean the filter and the inside of the filter
housing, taking care in case there are any
sharp objects.
Put the filter back in place and secure by
turning the lid in a clockwise direction.
The filters (1) and (2) should be checked from
time to time and cleaned if necessary.
The housing, plastic parts, such as buttons,
knobs etc. and the facia panel should only be
cleaned with appropriate mild cleaners or with
a damp cloth and wiped dry. Any scouring
agents will scratch the surface.
To clean casing parts made of stainless steel,
use an appropriate stainless steel cleaner.
Any scouring agents will scratch the surface.
Avoid contact of stainless steel surfaces with
liquid cleaning and disinfecting agents which
contain chlorine or sodium hypochlorite.
M.-Nr. 04 506 754
These agents can have a corrosive effect on
stainless steel. Aggressive vapours contain-
ing chlorine bleach can also be corrosive.
Do not store open containers of these agents
near the machine.
After use do not shut the machine door, but
leave it slightly ajar, to allow the machine to
dry out.
If the machine is not going to be used for a
longer period of time (4 weeks or more) the
drum should be rotated several times after
the last use. The drum should be rotated
every 4 weeks to prevent damage to the bear-
ings.
Should a fault occur please contact your near-
est Customer Service Dept.
When contacting the Customer Service De-
partment please give both the model and the
serial number (SN) of the machine.
These can be found on the data plate:
with the door open, or at the rear of the machi-
ne towards the top.
Only use genuine spare parts, when order-ing
spare parts the Spare Parts Dept will also
need to know the model and the serial num-
ber (SN) and Part No. (M.-Nr.).
Guide to the data plate
Model Model type
SN Serial number
Art.-Nr. Article number
Mat.-Nr. Part number
IBN Commissioning date
55