Additional Programmes; Possible Reasons For Increased Levels Of Foaming - Miele professional WS 5080 Mode D'emploi

Notes

Additional programmes

The following programme changes may only
be carried out by an authorized service engi-
neer
Programme "Sluice" (For Great Britain)
[2 pre-rinses, pre-wash,
main wash, 3 rinses, final spin]
Programme "Thermal disinfection without
pre-wash"
[final rinse at 70°C]
Programme "Chemo-thermal disinfection
without pre-wash"
[main wash 60°C (+2,-1°C),
10 minutes holding time and
final rinse at 70°C]
Programme "Incontinent laundry"
[3 pre-rinses, pre-wash, rinse,
main wash, 3/4/5 rinses, final
spin]
Programme "Thermal disinfection with
pre-wash"
[pre-wash at 95°C (+2, -1°C),
10 minutes holding time]
Programme "Sanfor test wash
[main wash,
holding time 40 minutes,
2 rinses:
1st rinse at 60°C, 6 minutes
holding time
2nd rinse at 60°C, 9 minutes
holding time,
final spin]
52
Possible reasons for increased levels of
foaming:
– detergent type
Only use detergent formulated for use in
commercial washer extractors. Domestic
laundry detergent is not suitable.
– overdosing of detergent
Dispense detergent following the deter-
gent manufacturer's instructions on the
packaging and in accordance with local
water hardness levels*.
– detergent creates too much foam
Use a lower foaming detergent or contact
your detergent application specialist.
– very soft water
In areas with hardness level 1 dispense
less detergent in accordance with the de-
tergent manufacturer's instructions.
– soiling level of the laundry
For lightly soiled laundry dispense less de-
tergent in accordance with the detergent
manufacturer's instructions.
– residues, e.g. detergent are left on
laundry
Run an additional pre-wash without deter-
gent and without selecting a temperature.
Laundry which has been soaked before
washing must be thoroughly
rinsed before running a wash programme.
– small loads
Reduce the amount of detergent dispen-
sed according to the size of the load.
M.-Nr. 04 506 754