Cleaning; Changing The Infrared Lamp - Beurer IL 50 Mode D'emploi

We recommend short treatment times at the begin-
ning. However, even when the unit is used correctly,
the skin of some people can have an oversensitive
or allergic reaction to the heat treatment (e.g. intense
redness, blisters, itching, heavy sweating).
Starting the unit
Important
• Always close or cover your eyes when radiating
the face.
• Press the On/Off switch (3)
• The unit will turn on automatically after a short time.
• The Time Display (4) will show 15 minutes
(Recommended treatment time).
• You can press the time selector (5) to reduce the
treatment time. Each push reduces the time by
1 minute.
• The infrared heat lamp switches off automatically
after the set time.
• To end the treatment before the timer runs out, use
the On/Off switch (3) and disconnect the power
plug.
Important
Do not touch the hot glass
During treatment
• Examine the part of the body treated frequently
and check for skin reactions. Cease exposure im-
mediately if there are any signs of oversensitivity
or an allergic reaction, and consult a doctor.
• The unit can be switched off at any time using the
On/Off switch (3).
• Do not cover up or pack the unit away while it is
still warm.
After treatment
• Switch off the unit at the On/Off switch (3).
• Pull the power plug out of the socket.
Note:
The bulb is fragile when hot. After operation, let the
device cool down before you move it.

7. Cleaning

Before cleaning the unit, switch it off, unplug it and
allow it to cool down completely before you touch
it or pack it away.
The unit can be cleaned with a damp cloth. Do not
use cleaning agents.
Ensure that no water enters the unit.

8. Changing the infrared lamp

NOTICE:
Remember that a faulty lamp should only be replaced
with a lamp of the same type.
WARNING:
Danger of electric shock!
• Before changing the lamp, switch the device off,
unplug it and allow it to cool down completely.
• Light bulbs are not covered by warranty.
• Risk of burning on hot surfaces!
NOTICE:
Always hold the bulb by the end, do not touch the bulb.
Procedure
1. Place the cool unit with the glass ceramic plate
down on a flat surface.
2. Using a suitable crosshead screwdriver, undo the
8 screws in the back panel.
3. Place the body so that the front ofthe glass ceramic
plate is lying on the flat surface.
6