Automatic Switch-Off; Switching Off; Cleaning And Maintenance - Beurer HK58-125XXL Mode D'emploi

WARNING
If the heating pad is being used over several hours, we recommend
that you set the lowest temperature setting on the controller to avoid
overheating the heated body part, which may lead to burns to the skin.

4.6 Automatic switch-off

This heating pad is equipped with an automatic switch-off function. This turns off the heat supply
approx. 90 minutes after the initial use of the heating pad. A part of the displayed temperature
settings on the controller then begins to flash. So that the heating pad can be switched back
on, the side sliding switch (3) must first be set to setting "0" (OFF). After about 5 seconds it is
possible to switch it on again.

4.7 Switching off

To switch the heating pad off, set the sliding switch on the side of the controller to setting "0" (OFF). The
temperature settings display is no longer illuminated.
NOTE:
If the heating pad is not in use, switch the side sliding switch for ON/OFF to setting "0" (OFF) and
unplug the mains plug from the socket. Then disconnect the controller from the heating pad by un-
plugging the plug-in coupling.

5. Cleaning and maintenance

WARNING
Before cleaning, always remove the mains plug from the socket first.
Then disconnect the controller from the heating pad by unplugging the plug-in coupling.
CAUTION
• The controller must never come into contact with water or other liquids, as this may cause damage.
To clean the controller, use a dry, lint-free cloth. Do not use any chemical or abrasive cleaning agents.
The textile cover can be cleaned in accordance with the symbols on the label and must be removed from
the heating pad prior to cleaning.
Small marks on the heating pad can be removed with a damp cloth and if necessary, with a little liquid
detergent for delicate laundry.
CAUTION
• Please note that the heating pad may not be chemically cleaned, wrung out, tumble dried, put
through a mangle or ironed.
This heating pad is machine-washable. Set the washing machine to a particularly gentle wash cycle at 30°C
(wool cycle). Use a delicate laundry detergent and measure it out according to the manufacturer's instructions.
CAUTION
• Please note that frequent washing of the heating pad has a negative effect on the product. The
heating pad should therefore be washed in a washing machine a maximum of 10 times during its
life.
Immediately after washing, reshape the heating pad to its original dimensions while it is still damp and spread
it out flat on a clothes horse to dry.
13
90
min
STOP