Automatic Switch-Off; Switching Off; Cleaning And Maintenance - Beurer HK Comfort Mode D'emploi

4.5 Automatic switch-off

This heating pad is equipped with an automatic switch-off function. This turns off the heat sup-
ply approx. 90 minutes after the initial use of the heating pad. The temperature setting display
then starts to flash. So that the heating pad can be switched back on, the sliding switch for ON/
OFF and temperature settings (5) must first be set to setting "0" (OFF). After about 5 seconds
it is possible to switch it on again.

4.6 switching off

To switch the heating pad off, set the sliding switch for ON/OFF and temperature settings to setting "0" (OFF).
The temperature settings are then no longer illuminated.
NOte:
If the heating pad is not in use, switch the side sliding switch for ON/OFF to setting "0" (OFF) and
unplug the mains plug from the socket. Then disconnect the controller from the heating pad by un-
plugging the plug-in coupling.

5. cleaning and maintenance

WARNING
Before cleaning, always remove the mains plug from the socket first. Then disconnect the controller
from the heating pad by unplugging the plug-in coupling. Otherwise there is a risk of electric shock.
cAutION
• The controller must never come into contact with water or other liquids, as this may cause damage.
To clean the controller, use a dry, lint-free cloth. Do not use any chemical or abrasive cleaning agents.
Small marks on the heating pad can be removed with a damp cloth and if necessary, with a little liquid
detergent for delicate laundry.
cAutION
• Please note that the heating pad may not be chemically cleaned, wrung out, tumble dried, put
through a mangle or ironed.
This heating pad is machine-washable. Set the washing machine to a particularly gentle wash cycle at 30°C
(wool cycle). Use a delicate laundry detergent and measure it out according to the manufacturer's instructions.
cAutION
• Please note that frequent washing of the heating pad has a negative effect on the product. The
heating pad should therefore be washed in a washing machine a maximum of 10 times during its
life.
Immediately after washing, reshape the heating pad to its original dimensions while it is still damp and spread
it out flat on a clothes horse to dry.
13
90
min
STOP