Festo EGC-TB-KF Notice D'utilisation page 26

EGC-TB-KF, EGC-HD-TB
Interfaces for mounting components
on the cover
e.g. with foot mounting HPE
(only for EGC-...-TB-KF)
1) è www.festo.com/catalogue
Tab. 1
Note
Danger of screws being pulled out if the axis is only mounted to the covers and the
torque load around the longitudinal axis is too great.
• If there are heavy loads, mount the axis to the profile with additional mounting
components.
• Tighten the mounting screws evenly with the following tightening torque.
Size
Screw (cover)
Tightening torque
Tab. 2
For installation in a vertical or inclined position:
Warning
Injury to people and material damage!
If there is a power failure or if the toothed belt
breaks, the work load will slide down.
• Make sure that you only use motors with an
integrated spring-loaded holding brake.
• Check whether additional external safety measures against damage due to breaking
of the toothed belt are required (e.g. toothed latches, moving bolts or emergency
buffers).
26
on the profile
1)
e.g. with slot nuts NST
50 70
M4 M5
[Nm] 2.9 5.9
1)
e.g. with profile mounting MUE
80 120
M5 M8
5.9 24
Fig. 5
Festo – EGC-TB-KF, EGC-HD-TB – 1505b English
1)
185
M10
47