Function For Conversion Of Video Signals - Sony HT-CT500 Mode D'emploi

Function for conversion of video signals

The subwoofer is equipped with a function for converting video signals.
Video signals and component video signals can be output as HDMI video signals (output from the
HDMI TV OUT jack only).
For conversion of images, see "Video input/output conversion table" (page 36).
Video input/output conversion table of the subwoofer
Rear of the
subwoofer
OUTPUT jack
INPUT jack
HDMI IN A The same type of signal as that of the input signal is output. Video signals are not up-
converted.
VIDEO IN B
Video signals are up-converted and output through this system.
COMPONENT
VIDEO IN C
Notes on converting video signals
• When video signals from a VCR, etc., are converted by the subwoofer and then output to your TV,
depending on the status of the video signal output, the image on the TV screen may appear distorted
horizontally, or no image may be output.
• If your VCR has an image improvement circuit, such as TBC, the images may be distorted or may
not be output. In this case, set the image improvement circuit function to off.
EZW-T100
BD IN BD IN DVD IN DVD IN SAT/CATV IN SAT/CATV IN
OPTICAL
ONLY FOR SS-CT500
L
TV IN
DIGITAL
CENTER
ASSIGNABLE
L
R
DC 5V ONLY FOR
0.7A MAX SS-CT500
SPEAKER
R
AUDIO IN
REMOTE
DMPORT CTRL TV
A B
Input signals
AM
FM
Output signals
75 COAXIAL
ANTENNA
ABC
TV OUT TV OUT HDMI
COAXIAL
VIDEO 2 IN VIDEO 3 IN VIDEO 3 IN
VIDEO IN VIDEO IN COMPONENT VIDEO IN
Y
P /
L B
C
B
P /
R
C
R
R
AUDIO IN
VIDEO 1 VIDEO 2 VIDEO 3
C
HDMI TV OUT
continued
35
US