Stiebel Eltron DHE Connect 18 Utilisation Et Installation page 96

INSTALLATION
Alternative installation methods
14.7 Water installation on finished walls with
solder/press-fit fittings
You can connect copper or plastic pipes using the accessories
"solder fitting" or "press-fit fitting".
With "solder fitting" with threaded fitting for 12 mm copper pipes,
proceed as follows:
f Push the union nuts over the connection pipes. f
f Solder the inserts to the copper pipes. f
f Push the lower back panel section under the connection f
pipes of the tap and push it into the back panel.
f Secure the connection pipes to the tee and the 3-way ball f
shut-off valve.
Note
Observe the tap manufacturer's instructions.
96 |DHE Connect | DHE Touch
14.8 Fitting appliance cover for water installation on
finished walls
4
3
2
1
1 Back panel guides
2 Screw
3 Cover guides with sealing lips on the pipe side
4 Pipe knock-out
f Cleanly saw and break out the pipe knock-outs in the appli- f
ance cover. If necessary, use a file.
f When installing the connection pipes without an offset, break f
off the sealing lips on the cover guides.
f Click the cover guides into place in the knock-outs. f
f Position the back panel guides on the pipes. Push them to- f
gether. Then push the guides against the back panel as far
they will go.
f Secure the lower back panel section with a screw. f
www.stiebel-eltron.com