Stiebel Eltron DHE Connect 18 Utilisation Et Installation page 88

INSTALLATION
Standard installation
f Install the appliance on the threaded studs of the wall f
mounting bracket.
f Push the back panel firmly against the wall. Lock the fixing f
toggle by turning it 90° clockwise.
f Pull the cable grommets into the back panel until both lock- f
ing tabs engage.
19
3 Nm
f Fit the pipes with flat gaskets onto the water connections. f
f Open the 3-way ball shut-off valve or the shut-off valve in the f
cold water inlet line.
Making the electrical connection
WARNING Electrocution
Carry out all electrical connection and installation work
in accordance with relevant regulations.
88 |DHE Connect | DHE Touch
24
5 Nm
WARNING Electrocution
The connection to the power supply must be in the form
of a permanent connection in conjunction with the re-
movable cable grommet. Ensure the appliance can be
separated from the power supply by an isolator that dis-
connects all poles with at least 3 mm contact separation.
WARNING Electrocution
Ensure that the appliance is earthed.
Material losses
!
Observe the type plate. The specified rated voltage must
match the mains voltage.
f Connect the power cable to the mains terminal. f
Fitting the lower back panel section
f Fit the lower back panel section into the back panel. Check f
that both locking tabs are engaged.
www.stiebel-eltron.com