Mail Report; Pc Communication - Sony SRX-S110 Manuel D'installation

Mail Report

The Mail Report window is used to set sending e-mail to
report the used time of the projection lamps or the
operating hours of the projector for maintenance to the
preset addresses.
Report Timing
Lamp Timer Reminder: Presets the timing when e-mail
is sent for reporting the used time of the lamps.
Maintenance Reminder: Presets the timing when e-mail
is sent for reporting the operating time of the projector
for maintenance.
Re-count: Resets the operating time when you check the
check box.
Reporting Sources/Destination
FROM: Enter the e-mail address from which e-mails are
sent.
Email Address: Enter the e-mail addresses to which you
send e-mails as TO and CC.
Reporting Contents
Error: Check the addresses to which you want to send e-
mail for reporting errors.
Lamp Timer/Maintenance: Check the addresses to
which you want to send e-mail for reporting "Lamp
Timer" and "Maintenance."
Mail Server
Outgoing Mail Server (SMTP): Enter the SMTP
(sending mail) server name or the IP address of the
SMTP server.
Requires Authentication: Selects whether authentication
is required when you send e-mails.
If authentication is required, check the check box and
select either way for authentication.
POP before SMTP: Selects when "POP before SMTP" is
necessary when e-mail is sent.
POP3 Server: Enter the POP3 server name or the IP
address of the POP3 server.
Account Name: Enter the user name to log in to the
POP3 server.
Password: Enter the password of the user to log in to
the POP3 server.
SMTP Authentication: Selects when "SMTP AUTH" is
necessary when e-mail is sent.
12
Setting Up the Projector
Account Name: Enter the user name to log in to the
SMTP server.
Password: Enter the password of the user to log in to
the SMTP server.
Send Test Mail: Selects whether you send a test mail.

PC Communication

The PC Communication window is used to configure for
communication between the projector and the computer
for controlling the projector.
Projector Identifying
Configures the projector.
Port No.: Enter the UDP port number.
Interval: Enter the interval at which the IP packets are
sent.
Broadcast Address: Enter the broadcast address.
: Registers the entered IP address in the list.
: Deletes the IP address from the list.
List box: Displays the registered broadcast addresses.
Controlling PC Destination
Configures the computer for controlling the projector.
Port No.: Enter the TCP port number.
Time-out: Enter the time when the communication is to
end.
Accept Connections from these hosts: Enter the IP
address of a host who is allowed to access the
projector.
: Registers the entered IP address in the list.
: Deletes the registered IP address from the list.
List box: Displays the registered IP addresses of the hosts
allowed to access the projector.
Network Block Reboot
Restarts the Network CPU after the PC Communication
settings complete. Click the REBOOT button to restart.