Berbel ConInterface Manuel De Montage page 40

Installation
3.5 Integrating AutoRun® 2.0 in the
extractor hood system
☞ Ensure that the extractor hood is
installed and connected correctly.
☞ Perform the following steps for the
control panel supplied with your
extractor hood.
Extractor hoods with control panel "V8"
☞ Press and hold the two buttons at
the same time (> 3 sec.) to start
the connection process.
Both buttons flash for 2 minutes.
Extractor hoods with control panel "V7"
☞ Press and hold the two buttons at
the same time (> 3 sec.) to start
the connection process.
Both buttons flash for 2 minutes.
40
Perform the following step if the buttons
on the extractor hood are flashing.
AutoRun® 2.0
☞ Press the button to start the
connection process.
The LED flashes for 2 minutes.
The "AutoRun® 2.0" device and extractor
hood are successfully connected by radio
if the LED lights up white for 10 seconds.
 For further information refer to the
instructions for the "AutoRun® 2.0"
device.
6005005_0 – 13.08.2020