Berbel ConInterface Manuel De Montage page 39

Installation
3.4 Integrating the remote control
BFB 6bT in the extractor hood
system
☞ Ensure that the extractor hood is
installed and connected correctly.
Perform the following steps in parallel on
the remote control and on the extractor
hood.
Remote control BFB 6bT
☞ Press and hold both buttons at the
same time (> 3 sec.) to start the
connection process.
Both buttons flash for 2 minutes.
 For further information refer to the
instructions for the remote control
BFB 6bT.
☞ Perform the following steps for the
control panel supplied with your
extractor hood.
6005005_0 – 13.08.2020
Extractor hoods with control panel "V8"
☞ Press and hold both buttons at the
same time (> 3 sec.) to start the
connection process.
Both buttons flash for 2 minutes.
Extractor hoods with control panel "V7"
☞ Press and hold both buttons at the
same time (> 3 sec.) to start the
connection process.
Both buttons flash for 2 minutes.
The remote control and extractor hood
are connected with the device by radio.
39