Scheppach HMS1080 Traduction Des Instructions D'origine page 36

Workpiece has been processed
against the direction of growth
Too little work-
piece feed when
thicknessing
Too much material planed off
at once
Chip ejection
High degree of chip take-off
clogged when
Blades are blunt
thicknessing
(without suction
Wood is too wet
system)
High degree of chip take-off
Chip ejection
Feed to high
clogged when
planing (without
Blades are blunt
suction system)
Wood is too wet
Clogged chip
ejection with
Chip extraction system is too
suction system
weak
when planing or
thicknessing
36 | GB
Clean the table top and treat it thinly with glide wax
Repair the transport rollers
Reduce chip take-off
Change blades
Use a dry workpiece
Reduce chip take-off
Reduce the feed speed
Change blades
Use a dry workpiece
A chip extraction system must be used, which guarantees
an air speed of at least 20 m/s at the suction connection
nozzle
www.scheppach.com