Insertion Of The Mould; Closing Of The Maschine And Selection Of The Press Capacity - BEHAbelt HP01 Mode D'emploi

6.3

Insertion of the mould

6.4 Closing of the machine and selection of the press capacity
To close the upper part precisely installed on the
lower part between the guide webs. During overlap
welding the upper part and the lower part initially
not touch. The material has yet to be displaced
during the welding process or during the holding
time.
Insert the mould centrally and lengthwise into the press.
Release the bolt lever so that the profile material can be
compressed.
The notches within the mould and top plate of the enclo-
sure must align exactly. Connect the mould breadth wise
to the plastic stoppers.
Turn the star handle to the right until the above and lower
moulds are touching.
Thereafter star handle continue to turn until the screw
heads stand 3-4 mm from the upper case plate.
The guideway levels the above heater coplanar to the lower
heater.
For this reason, the areas of contact must be lying exactly
in contact with each other. Release bolt lever so that mate-
rial can be compressed.
39