Welding; Set Up Of The Belts That Need To Be Welded; Set Up Of The Eergo Paddle Welding Tool - BEHAbelt EErgo 60 Mode D'emploi

2.0 Welding

2.1 Set up of the belts that need to be welded

• Recommendation: Heating up the belts to room temperature to achieve
the best welding result.
• Cut the ends of the belt to be connected flat.
• Fix the belt in the guide clamp FZ01 or FZ02/3 or the flat belt in the
guide clamp FZ02/3F and align the ends.

2.2 Set up of the EErgo paddle welding tool

• Plug in the welding tool into the socket.
• Set up the temperature by pressing the button TPE or PU.
• Red LED indicates that the tool is heating up.
• Wait with welding until the LED lights up green.
• To change the temperature press the corresponding button.
• The red LED indicates either that the product is heating up or cooling
down.
• Wait with welding until the LED lights up green.
• Check the temperature of the paddle welding plate using a temperature
measuring device with surface sensor every now and then.
29