Closing Of The Machine And Selection Of The Press Capacity; Beginning Of The Heating Process Of The Hp01 Controller; Exposure Time - BEHAbelt HP01 Mode D'emploi

5.4

Closing of the machine and selection of the press capacity

5.5

Beginning of the heating process of the HP01 Controller

Press , select recipe with arrow buttons (keypad button "2" and "8") accordingly and
confirm with
Press button and the welding process will begin and end automatically.
5.6

Exposure time

The exposure time starts automatically as soon as the above and lower heaters have
reached the set-temperature.
36
Turn the star handle to the right until the above and lower
moulds are touching. Thereafter star handle continue to
turn until the screw heads stand 3-4 mm from the upper
case plate.
The guideway levels the above heater coplanar to the lower
heater.
For this reason, the areas of contact must be lying exactly
in contact with each other. Release bolt lever so that mate-
rial can be compressed.
Connect PPuls Controller with the power line and switch on
the controller. Selection of welding parameters through di-
rect entry or selection of stored recipes.
4.5.1 Direct entry of welding parameters
Press
Change values by entering the number of the number field,
confirm with
Press
end automatically.
Please refer to recommended welding parameters on page 2.
4.5.2 Selection of stored recipes
.
: Long to change current setting.
, delete/abort with
button and the welding process will begin and
.