Waeco MagicWatch MWE900 Instructions De Montage Et De Service page 50

_MWE-900.book Seite 50 Freitag, 12. Januar 2007 4:53 16
Using the parking aid
The display shows the following status messages:
Display Description
Factory settings activated
F5
Your own settings
C5
You can change the settings as follows:
➤ Press one of the buttons for longer than two seconds.
✓ The display shows the number of the first parameter: 01.
You can set the parameters according to the table below:
No. Parameter
Loudspeaker volume
01
Range of the middle
04
sensors
Range of the outer sen-
05
sors
Stop zone of the middle
08
sensors
Stop zone of the outer
09
sensors
Suppress display of
10
solid objects
Gearbox type
13
➤ Select the parameter to be changed:
– Press the left-hand button to increment the parameter.
– Press the right-hand button to decrement the parameter.
✓ The display shows the number of the selected parameter, e.g. the range
of the middle sensors: 04.
➤ Press the right-hand button for longer than two seconds.
✓ The display shows the number of the selected parameter, it flashes,
e.g.: 80.
50
Possible val- Factory
ues setting
0, 1, 2 2
120 – 180 cm 160
50 – 95 cm 55
30 – 70 cm 30
30 – 70 cm 30
0, 1 0
0, 1 0
MagicWatch MWE900
Comment
0 = Off
1 = Low
2 = High
The display shows 20 to
80.
1 = Function activated
1 = For automatic
gearbox