Waeco MagicWatch MWE900 Instructions De Montage Et De Service page 47

_MWE-900.book Seite 47 Freitag, 12. Januar 2007 4:53 16
MagicWatch MWE900
Connecting the loudspeaker (fig. i, page 9)
➤ Connect the cables for the loudspeaker as follows:
– Yellow cable (5): slot 15 in the plug of the connection cable
– Blue cable (6): slot 3 in the plug of the connection cable
Connecting the radio (fig. i, page 9)
You can mute the radio while the loudspeaker is active.
➤ To do this, connect the grey cable (7) to the radio's mute input.
Connecting the sensors (fig. i, page 9)
Note
The sensor plug polarities cannot be reversed: they can be only be
plugged into the connection in one way.
For the control unit to be able to assign the sensors correctly, insert the short-
est connection cable in the sensor fittest nearest to the control unit
(sensor 1). Connect the sensor fittest furthest away to the longest connection
cable (sensor 4).
➤ Plug the sensors with the black rubber mark into the sockets on the sen-
sors in the middle (9).
Make sure the locking pin engages.
➤ Plug the sensors with the blue rubber mark into the sockets on the sen-
sors in the outside (8).
Make sure the locking pin engages.
Fitting the parking aid
47