Hitachi NT 65A2 Mode D'emploi page 5

(3) After inserting the nails, pull the nail feeder up in
backward direction, remove it from the roll pin, move
it slowly forward and push the nail.
NOTE:
After having removed the nail feeder from the roll pin
and moving it forcefully forward, the nail coupling
may brake and the nail feeder may get caught between
the magazine and nails, causing poor nail feeding.
Therefore, move the nail feeder slowly forward.
CAUTIONS
To prevent unintentional operation, never touch the
trigger or place the top end of the push lever on a work
bench on floor. Also, never face the nail outlet toward
any part of a person.
Use nails in which five nails are connected.
HOW TO USE THE NAILER
CAUTIONS
Never use the head or body of this device as a hammer.
Take precautions to ensure the safety of persons in the
vicinity during operation.
1. Nailing procedures
(1) Intermittent nailing
Depress the nail outlet onto the desired point; then
pull the trigger to drive a nail in a single shot. (See Fig.
3)
1
Push Lever
CAUTION
This tool will sometimes fire twice in rapid succession
when strongly pressed flush against a surface or
when using on hard materials. In such cases, fire the
nails by squeezing and quickly releasing the trigger.
(2) Push lever
When depressing the nail outlet, be sure to fully lift the
push lever (See Fig. 3) to release the safety lock. Thus,
nails cannot be driven without releasing the safety
lock even though the trigger is pulled.
(3) Continuous nailing
First, pull the trigger. Then depress the devise onto the
desired position to automatically drive nails. (See Fig.
4).
2
3
Trigger
Fig. 3
Previously pull the trigger.
2
CAUTION
Excercise care when nailing corners of lumber. When
continuous nailing corners of lumber, a nail may go
astray or break through the corner.
NOTES
Precautions on no-load operation
Sometimes nailing will continue after driving in all
nails previously contained in the magazine.
This is termed "no-load operation". Such operation
may deteriorate the damper, magazine, and nail feeder.
To avoid no-load operation, occasionally confirm the
amount of remaining nails. On the other hand, all nails
should be removed after using this nailer.
After completing operation, put into the body about
2cc oil through the hose joint to protect the tool from
rust.
Under low temperature conditions, the machine
sometimes does not operate correctly. Always operate
the machine at the appropriate ambient temperature.
2. Attachment and detachment of the nose cap
CAUTIONS:
When attaching and detaching the nose cap, make
sure to disconnect the hose to release the compressed
air.
When attaching and detaching the nose cap, make
sure to take your finger off the trigger.
When you do not want to cause scratches in the material
you work with, use the accessory rubber nose cap. To
attach the nose cap, attach it as shown in Fig. 5. Detachment
shall be made in reversed order. Also, when attaching the
nose cap, the drive bit projection of the nail outlet will be
reduced and the nailing power will be lowered. Adjust the
nailing power according the air pressure used and the
attachment position of the bit guide.
2
Nose Cap
English
1
Fig. 4
1
Push Lever
Disconnect air hose
Fig. 5
4