Hitachi NT 65A2 Mode D'emploi page 4

English
NAIL SELECTION
Choose a suitable nail from Fig. Nails which are not
shown in Fig. can not be driven with this tool.
2.8mm (.110")
1.4mm
(.054")
Dimensions of nails
STANDARD ACCESSORIES
(1) Hexagon bar wrench for M5 screw ........................... 1
(2) Eye protector .............................................................. 1
(3) Oiler ............................................................................. 1
(4) Nose cap ..................................................................... 1
OPTIONAL ACCESSORY
Sequential Fire Parts Set (Code No.876-762)
With the sequential fire parts,the nail is driven only
by squeezing the trigger after pushing down the
push lever.
By installing these parts, driving nails into improper
positions and unexpected firing of nails caused by
accidental operation of the push lever can be
prevented.
APPLICATIONS
Nailing as a finishing process for areas around the
doors, windows as well as edgings.
Securing the bottom of drawers. Making various cases
and cabinets.
PREPARATION PRIOR TO OPERATION
1. Prepare the hose
Be sure to use the hose provided with minimum
6 mm (1/4") inside diameter.
NOTE:
The air supply hoses must have a minimum working
pressure rating of 12.8 bar (180 psi) or 150 percent of
the maximum pressure produced in the air supply
system, whichever is higher.
2. Check on safety
CAUTIONS:
Unauthorized persons (including children) must be
kept away from the equipment.
Wear eye protector.
Check the retaining screws which fix the exhaust
cover, etc. for tightness.
Check the nailer for air leaks and defective or rusty
parts.
3
BEFORE USE
1. Check the air pressure
CAUTION:
1.65mm
(.65")
2. Lubrication
(1) Prior to operating this nailer, be sure to provide an air
(2) It is recommended using the recommended oil (SHELL
3. Load nails
(1) Pull the nail feeder back and hang it over roll pin
(2) Insert nails from above one group at a time using your
Check whether or not the push lever works correctly.
Also check whether or not any dirt has adhered to the
moving parts of the push lever.
Recheck on operational safety.
The air pressure must be constantly maintained at 4.9
– 8.3 bar (70 – 120 psi.).
Adjust the air pressure between 4.9 to 8.3 bar (70 ~ 120
psi.) according to the diameters and length of nails
and hardness of the wood being nailed. Pay special
attention to the output pressure, capacity, and piping
on the air compressor, so that air pressure does not
exceed the specified limit. Note that excessive pressure
may affect overall performance, service life, and safety.
set between the air compressor and this device.
Lubrication through the air set offers smooth operation,
extended service life, and anticorrosion.
Adjust the oiler so that a single drop of oil is supplied
at intervals of 5 to 10 nailing cycles.
TONNA). Other applicable oils are listed. Never mix
two or more types of different oils.
secured to the magazine. (See Fig. 1)
Nail Feeder
Roll Pin
Fig. 1
hand to move them forward in the magazine. (See Fig.
2)
1
2
Nail strips
Fig. 2
Magazine