Adjusting The Inclination - JANE CONCORD Transformer iPLUS Mode D'emploi

It is important to ensure that the belts are always correctly positioned each time the
seat is used. If in doubt about any aspect of fitting, check with JANÉ-CONCORD.
The seat belts must go through the belt guides marked in green on the safety seat.
The belts must not be used in any other position.

_ ADJUSTING THE INCLINATION

To use the inclination adjuster on the TRANSFORMER, press the seat inclination
button (04) on the front edge of the seat. 5.a
Keeping the button pressed, move the seat into the required position.
The angle of the TRANSFORMER can be adjusted without setting the reclining angle
to a specific position. Simply release the seat reclining button (04) and the seat will
remain in the set position. 5.b
EN
32