How To Use The Energy-Saving Functions - Thermor Amadeus évolution Notice D'utilisation Et D'installation

HOW TO USE THE ENERGY-SAVING FUNCTIONS

To use these functions, we recommend that you set the cursor A to Comfort
mode.
These functions are in addition to the programming functions.
ACTIVATING THE AIRING DETECTION FUNCTION
Do not heats the room while it is being ventilated allow you to save energy. If you do not turn off your
heater when a window is open for a long time, the airing function
when it is not necessary: your heater automatically detects when the window is opened or closed and
therefore saves energy.
Your device reacts to an open or close window according to several variables, especially
- the temperature settings programmed for the room
- the outside temperature
- the location of your heater, etc.
By detecting whether the window is open or closed,
the airing function helps you to be environmentally friendly: you save energy by not heating your house
when you ventilated it.
NB: If the function does not meet your requirements, you can manually stop the panel heater from heating
(Stand-by mode ). When the function is running, the green LED flashes slowly.
To activate the airing detection function:
Turn control knob B to position
B
The operating instructions are for 7°C ±3°C for
the whole time that your room is being aired.
When you close the window, your panel heater
will return to its initial operating mode.
After 2 hours, the appliance starts heating
again in any case.The maximum expected
airing period is 2 hours.
31
or Programming
stops your device from heating
Optimum zone
GB