Unlocking The Panel Heater's Hanging Frame; Fixing The Hanging Frame To The Wall - Thermor Amadeus évolution Notice D'utilisation Et D'installation

UNLOCKING THE PANEL HEATER'S HANGING FRAME

We recommend that you place the panel heater face down on the floor, taking care to protect its
front surface from scratches.
Take a flat-bladed screwdriver and lift the
1
slider, taking care not to bend it.
Swivel the hanging frame downwards on
3
the lower brackets S1.

FIXING THE HANGING FRAME TO THE WALL

Place the
1
hanging
frame on
the floor
against the
wall. Locate
drilling
points A.
Drilling points A show the position for the
lower fastenings.
Drill the 4 holes and insert the wall plugs.
3
Use suitable wall plugs when fitting on a
specific support (e.g. plasterboard wall).
S1
Drilling
points A
While keeping the slid-
2
er raised, push the
hanging frame towards
the bottom of the
heater to release the
upper brackets S2. We
recommend that you
wear protective gloves.
Remove the hanging frame.
4
Refit the hanging
2
frame, lining up
with drilling
points A to find
drilling points B
(you can also use a
level).
Drilling points B show the position for the
upper fastenings.
Position the hanging frame and screw it
4
down.
24
S2
Drilling
points B
Drilling
points A