Troubleshooting - Thermor Amadeus évolution Notice D'utilisation Et D'installation

P
ROBLEM
ENCOUNTERED
The panel heater
does not heat.
The panel heater
heats all the time.
The panel heater's
surface is very hot.
The panel heater
does not follow its
programming
instructions.
The heating light E
flashes rapidly (lit 0.5
seconds, unlit 0.5
seconds).
The consumption
indicator light D flas-
hes rapidly (lit 0.5
seconds, unlit 0.5
seconds).

TROUBLESHOOTING

- Check that the cursor is on position
- If you are operating under programming, check that the programmer is in
COMFORT mode.
- Ensure that the installation's circuit breakers are engaged and that the power
cut-off (if you have one) has not cut off the power to the panel heater.
- Check the air temperature in the room: if it is too high, the heating light E
does not illuminate: the panel heater does not heat.
- Check that the control knob B is not in Airing position
are no draughts.
- Check that the panel heater is not in a draught or that the temperature set-
ting ha not been altered.
- There may be a fluctuation in the main power supply. If there is a problem
(blocked thermostat...), cut off the power to the panel heater (fuse, circuit
breaker) for approximately 10 minutes and then switch it back on.
- If the phenomenon recurs frequently, have your electricity utility check the
power supply.
It is normal for the panel heater to be hot when it is operating; the maximum
surface temperature is restricted in accordance with the NF electrical per-
for-mance standard. However, if you think that your panel heater is still too
hot, check that the output is suitable for the area of your room (we recom-
mend 100W / m2) and that the heater is not placed in a draught, which would
interfere with its self-regulation; also check that the installation guidelines
have been followed (curtains, etc.)
Ensure that the energy controller or programming unit is being used correct-
ly (see the user's manual).
The measurement sensor has deteriorated.
Contact your installer.
Your panel heater's absence detector is disconnected or is not working.
Contact your installer.
The functions other than absence detection still remain operational.
C
HECKS TO BE MADE
.
38
and that there