Thermor Amadeus évolution Notice D'utilisation Et D'installation page 32

If you have a programmer:
PROGRAMMING THE HEATING PERIOD:
Using the programming, you can adjust your panel heater's settings to suit your lifestyle.
By connecting the pilot wire to a programmer, or if you use an on-board programmer (available as
an option), you can programme your Comfort
instructions included with your programmer).
You can connect several appliances to one programmer.
The temperature set on the control knob C is the base temperature that will serve as a reference
for the desired temperature according to the programming.
Order on your program-
ming box
COMFORT -1°C
COMFORT -2°C
ECO
FROST
STOP
Set the Comfort temperature that will
1
serve as a base for programming my
reductions in temperature:
Set the temperature control knob C to
the desired temperature.
NB : When there are no instructions from the pilot wire, the appliance heats in Comfort mode
The instructions for Frost
The changeover time is around 12 seconds when switching from Comfort mode
mode
HOW TO USE PROG MODE
-1°C with respect to the setting on the knurled knob C
-2°C with respect to the setting on the knurled knob C
-3.5°C with respect to the setting on the knurled knob C
Ambient temperature held at around 7°C.
Immediate switch off of the heating (used to disconnect the power).
C
and Stop
and temperature periods (please refer to the
Lower
Set the cursor A to position
2
E
The heating light E illuminates if the room's
ambient temperature is below the desired
temperature for the selected mode
(Comfort temperature in Comfort mode
and reduced temperature in Eco mode
take priority over Eco mode
30
A
PROG
).
.
and Comfort mode
to Eco
.