Technical Data Belt Drive Rt80; Mounting The Drive Motor - THOMSON WIESEL FORCELine Instructions De Montage Et De Maintenance

Mechanical Linear Drive Unit WIESEL FORCELine

Technical Data Belt Drive RT80

1)
Total weight [kg]
1) 2)
Idle torque , [Nm]
Mass moment of inertia
Maximum transmittable torque [Nm]
1) With DKWN tension sets:
For profile diameter 20 mm on WIESEL side,
profile diameter 24 mm on motor side
2) Static measurement

Mounting the drive motor

The electrical installation and the checking of
the direction of rotation may only be carried
out by a licensed electrician.
Before mounting the drive, check the direction of rota-
tion of the linear unit and the operation of the safety
limit switches. To do this, proceed as follows:
Connect the motor in compliance with the
Electro-technical regulations.
Fig. 9
Designation
Pos.
1 Motor
2 Second coupling half
3 Toothed wheel
4 First coupling half
5 Motor adapter flange
30
1) [kg/cm 2 ]
®
RT 80 (i = 1:1)
5.52
0.7
4.65
30
1. Fig. 9: Place the motor (1) in mounting position
beside the linear drive unit.
2. Switch on the motor and check the direction of
rotation in association with the safety limit switches
(if necessary, change the direction of rotation by
connecting the motor differently).
3. Attach the coupling half (4) to the shaft of the linear
drive unit.
4. Attach the motor adapter flange (5) to the fixed
bearing housing (6) with four screws.
5. Push the toothed wheel (3) onto the coupling half
on the linear drive unit.
6. Mount the second coupling half (2) on the drive
shaft of the motor.
7. Attach the motor with the coupling half to the
motor adapter flange (5) with four screws. Ensure
that no axial pressure is exerted on the motor shaft.
If necessary, correct the distance between the two
coupling halves.
RT 80 (i = 2:1)
6.95
0.7
10.38
30