Tectro TAW 200 Manuel D'utilisation Et D'installation page 45

Running mode.
Pressing the run/stand-by mode button again the heat pump boiler switches
back to the stand-by mode.
 And  buttons
These are the multi-purpose buttons. Used for parameter checking,
parameter setting, clock adjustment, adjustment of the timer and lock and
unlock the user interface (child lock ).
Check and adjust the set parameters.
PARAMETER CHECKING.
Press  or  button, in running or stand-by mode, to check the relating
•
set parameters. Press the run/stand-by button
action to the buttons for 5 seconds, the controller will exit the parameter
checking automatically.
PARAMETER SETTING.
• Parameters can only be set and/or changed in stand-by mode. If the
parameters need to be adjusted select the parameter which need to be
adjusted. Press  or  button first, the parameter and the default value starts
to flash. Pressing the  or  button again, the next parameter appears. Select
the parameter which needs to be adjusted. Then press
the same time to enter the parameter set program. Only the default value
flashes. Change the default value by pressing the  or  button. Press
button to confirm the setting. If the settings are not confirmed within 5
seconds, the unit will save the settings automatically.
Check chapter F to see which parameters can be adjusted. Adjusting
parameters which are marked as "Do not change" in chapter F should not
be adjusted. Otherwise malfunction of the heat pump boiler may occur.
CHILD LOCK.
Press  and  buttons at the same time and hold it for 5 seconds; the buttons
•
are locked.
Illustration 11
Illustration 12
to exit the checking. If no
and buttons at
4
45