Tectro TAW 200 Manuel D'utilisation Et D'installation page 33

electrician or your supplier.
• Never use an extension cable to connect the device to the electric power supply.
If there is no suitable, earthed wall socket available, have one installed by a
recognized electrician.
• Do not stop the heat pump boiler by pulling out the power plug. Only use the
dedicated buttons on the heat pump boiler.
• Do not open the heat pump boiler when it is in operation. Always pull out the
electrical plug when opening the device.
• Always pull out the electrical plug when cleaning or servicing the heat pump
boiler.
• Do not cover the air inlet and air outlet.
• Never allow the device to come into contact with chemicals.
• Never spray the heat pump boiler with or submerge in water.
• Do not operate the buttons or touch the heat pump boiler with wet hands.
• Do not insert hands, fingers or objects into the openings of the heat pump boiler.
• Do not make any modifications to the heat pump boiler other than described in
this manual.
• Do not remove insulating material.
• This appliance is not intended for use by persons (including children) with reduced
physical, sensory or mental capabilities, or lack of experience and knowledge,
unless they have been given supervision or instruction concerning use of the
appliance by a person responsible for their safety.
• Children should be supervised to ensure that they do not play with the appliance.
• The device must be placed and mounted on a stable surface.
• Install the heat pump boiler securely on a floor surface which can bear the weight
of the heat pump boiler FILLED WITH WATER. When installed on an insufficiently
strong floor surface, the heat pump boiler could fall causing injuries and/or
damage.
• Perform the installation securely referring to the installation instruction (see
chapter C). Incorrect installation could cause a personal injury due to fire, electric
shock, the heat pump boiler falling or leakage of water.
• Perform the drainage/piping work according to the installation instruction (see
chapter C).
• If there is a defect in the drainage/piping work, water could leak from the heat
pump boiler and could cause injuries and/or damage.
• The temperature of the liquid to the secondary heat exchanger must remain
below 70 °C at all times.
Have any repairs and/or maintenance only carried out by a Tectro
authorized dealer. Follow the instructions for use and maintenance as
indicated in the user manual of this device.
4
33