Using The Memory Function - Omron MIT Elite Plus Mode D'emploi

HEM-7301-ITKE_main.book Page 25 Friday, October 3, 2008 12:42 PM
3.4

Using the Memory Function

This unit has a memory capable of storing 90 sets of readings. Every
time you complete the measurement, the unit automatically stores the
blood pressure and pulse rate.
If there are three readings within 10 minutes of the last reading, the
average of the three readings is displayed.
Note: When 90 sets of readings are stored in memory, the oldest set
will be deleted to store a new set.
1.
Press the Memory button (
If there are three readings stored in memory that were taken
within 10 minutes of the last reading, an average value for
those reading is displayed. (If there are only two readings in
memory for that period, the average will be based on two
readings. If there is only one reading in memory for that period,
that reading will be displayed as the average value.)
Note: If there are no measurements
results stored in memory, the screen
to the right is displayed.
).
3.Using the Unit
EN
25