Husqvarna AUTOMOWER 105 Manuel D'utilisation page 22

5.2 Battery
WARNING:
product using a charging station and
power supply which is intended for
it. Incorrect use may result in electric
shock, overheating or leakage of
corrosive liquid from the battery. In
the event of leakage of electrolyte
flush with water and seek medical
help if it comes in contact with the
eyes etc.
WARNING:
batteries recommended by the
manufacturer. Product safety cannot
be guaranteed with other batteries.
Do not use non-rechargeable
batteries.
CAUTION:
The battery must be
charged fully before winter storage.
If the battery is not fully charged it
can be damaged and in certain
cases be rendered useless.
The charging time can vary depending on,
among other factors, the ambient temperature.
Below indicates that the battery is getting old
and eventually needs replacing:
• The operating time for the product is
shorter than normal between charges.
This leads to more charging cycles than
normal, which increases the risk of tracks
forming near the charging station.
• The product is found standing out on the
Empty battery message. This
lawn with
indicates that the product does not have
battery capacity enough to find the
charging station.
The battery is fine as long as the product
maintains a well-cut lawn.
Note:
Battery life is dependent on the length
of the season and how many hours a day the
22 - Maintenance
Only charge the
Use only original
product is operating. A long season or many
hours of use a day means that the battery
must be replaced more regularly.
Contact your local Husqvarna representative
to replace the battery.
5.3 Replace the blades
WARNING:
screws of the right type. Husqvarna
can only guarantee safety when
using original blades. Only replacing
the blades and reusing the screw
can result in a screw wearing during
mowing. The blades can then be
propelled from under the body and
cause serious injury.
Replace worn or damaged parts for safety
reasons. Even if the blades are intact, they
should be replaced on a regular basis for the
best mowing result and low energy usage. All
3 blades and screws must be replaced at the
same time to obtain a balanced cutting
system. Use Husqvarna original blades
embossed with the crowned H-mark logotype,
refer to Warranty terms on page 34 .
5.4 To replace the blades
1. Switch off the product with the main
switch or the ON/OFF button.
2. Turn the product upside down. Place the
product on a soft and clean surface to
avoid scratching the body and the hatch.
3. Rotate the skid plate so that its holes
align with the screws for the blade.
4. Remove the 3 screws. Use a straight slot
or cross-tip screwdriver.
5. Remove each blade and screw.
1418 - 004 - 10.03.2020
Use blades and