Battery Safety; Installation; Connecting The Power Supply - Husqvarna AUTOMOWER 105 Manuel D'utilisation

and the indicator lamp is lit. The correct
PIN code must also be entered for the
product to start.
• The product must never be used at the
same time as a sprinkler. Use the
Schedule function so the product and
sprinkler never run simultaneously.
• Husqvarna does not guarantee full
compatibility between the product and
other types of wireless systems such as
remote controls, radio transmitters,
hearing loops, underground electric
animal fencing or similar.
• The built-in alarm is very loud. Be careful,
especially if the product is handled
indoors.
• Metal objects in the ground (for example
reinforced concrete or anti-mole nets) can
result in a stoppage. The metal objects
can cause interference with the loop
signal which then can lead to a stoppage.

3.1 Connecting the power supply

Take the following into consideration when
planning where to place the power supply:
• Close to the charging station
• Protection from rain
• Protection from direct sunlight
WARNING:
be used with a power supply unit
supplied by Husqvarna.
When connecting the power supply, only use
a wall socket that is connected to an earth
fault-breaker (RCD).
WARNING:
Install only to an earth-fault breaker
(RCD) when connecting the power
supply to the wall socket. For USA/
CANADA: Use a covered Class A
GFCI receptacle (RCD) that has an
enclosure that is weatherproof with
1418 - 004 - 10.03.2020

3 Installation

The product is only to
Risk of Electric Shock.
• Operation and storage temperature is
0-50 °C / 32-122 °F. Temperature range
for charging is 0-45 °C / 32-113 °F. Too
high temperatures might cause damage
to the product.

2.3 Battery safety

WARNING:
can explode or cause fire if
disassembled, short-circuited,
exposed to water, fire, or high
temperatures. Handle carefully, do
not dismantle, open the battery or
use any type of electrical/
mechanical abuse. Avoid storage in
direct sunlight.
For more information about the battery, refer
Battery on page 22
to
the attachment plug cap inserted or
removed.
WARNING:
supply must be changed or
tampered with. The low voltage
cable must not be shortened or
extended.
Low-voltage cables of different lengths are
available as accessories.
WARNING:
cable and extension cable must be
outside the work area to avoid
damage to the cables.
Lithium-ion batteries
No parts of the power
The power supply
Installation - 13